|
¡¡
PRE-INSTALLATION
INSTRUCTIONS
¡¡
We highly advise professional installation
1. Check the headlight housings to ensure they are not damaged.
2.Make sure the vehicle does not have any pre-existing
electrical problems.
3.Vehicles with a single fuse for both lights must have a fuse
at least 30 amps.
If there is one fuse per headlight, each fuse must be at least
20 amps.
4. Identify the ballast's positive and negative wires.
5.Never touch any bulb with your bare hands. If touched
accidentally, use alcohol to clean the surface.
6.Before connecting the wires and harness, you must clean all
connectors, especially the AMP connector. Make sure the
installation is in A DUST FREE condition.
7.Do not look into the light directly when the HID is lit up to
avoid visual hazards.
8.Please do not install the ballast, the igniter, and the
connection wires close to the engine or places where
water may penetrate to avoid any overheating or
leakage.And donot open the ballast!
Step by Step Installation 1-2-3
Easy installation in general goes like 1-2-3-done as
described below.
Step 1:
After disconnecting power to the two headlamps and after
removing the bulb access covers of the low beam, high
beam or both bulb access covers, drill a small hole in
the removed cover. The HID-Xenon bulb wire is passed
through this hole for your headlamp upgrade. On the wire
is a supplied adjustable tight rubber waterproof grommet
to be fitted into the hole. Next, the HID-Xenon D2S/R
bulb is fitted into the headlamp's base and locked into
position via the factory locking device. No cutting of
wiring is required on the installation.
Step 2:
Reinstall the access panel and close it. Secure the
small ballast to a convenient location in the motorbay.
Step 3:
Finally attach power to the headlamp in the normal
manner and the upgrade is completed. Headlamp
realignment is recommended but only required if you have
removed the headlamp during the upgrade which sometimes
can be avoided (model and side dependant).
It takes about 1-2hours to complete the installation. No
special tools are required. Normal handtools only.
BONUS: Each upgrade kit is easily reversible or
transferable! When you decide to sell your car , it will
only take a few moments to reverse the installation and
re-install your original halogen bulbs as they were
before. You can either sell the HID upgrade system or
re-install it on your next car with same or different
bulb setup. All you need to do is seal the small hole on
the bulb access cover and you are done. | 
